Hi,

Well most things like that will be done with plenty of wet-sanding to remove that raised edge around the sticker. I'd wager that part has been sprayed 2-3 times. 

However, I've done it before with infusion. If you can work out a way to get the positioning correct (obviously the sticker needs to go into the mould with the surface down, which means you can't stick it in place), then you can put the sticker into the infusion stack and it will just be part of the laminate. This is my preferred method, but it is difficult to make sure the sticker stays where you want it. Nothing worse than going through all that effort only to find your sticker is on an angle when you demould.  

Please Help.

Thanks !

I didn't find the right solution from the internet.

References:

http://www.talkcompo=tes.m/23293/Ps-or-Brands-on-Carbon-parts 

Hotel Management Marketing Examples